2026-11-13 · Birdia Blog

What Causes a Push or a Pull in Golf?

Quick answer: Because the face and path point to the same side at impact. According to TrackMan, the face determines roughly 75-85% of the ball's start direction. When the path matches it, there's no sideways curve — the ball flies straight but off-line: right is a push, left is a pull.

What Happens at Impact: Face and Path Match Each Other, Not the Target

The ball flight laws popularized by TrackMan separate two numbers: clubface angle (where it points at impact) and swing path (where the clubhead is moving). The face carries the most weight in start direction — roughly 75-85%. That's more true with the driver and a bit less with higher-lofted irons, where path has slightly more influence. Curve, on the other hand, comes from the gap between face and path (face-to-path).

That's where the straight push or pull comes from:

The PGA Teaching Manual lists these among the nine basic ball flights: push and pull are the straight shots with a missed start line. Here's the key: your strike is consistent — it's just aimed at the wrong spot. That's usually easier to fix than a slice.

Common Causes of a Push (Starting Right)

Common Causes of a Pull (Starting Left)

How to Diagnose and Fix It

1. Check your alignment first. Lay a club on the ground parallel to the target line and make sure your feet, hips, and shoulders match it. It's the cheapest thing to rule out.

2. Read your divot (with irons). Its direction gives you a rough read on path: pointing right means an in-to-out path heading right, pointing left means it's heading left.

3. Check ball position against a fixed reference off your lead foot, and keep it consistent for each club.

4. If it's a pull from coming over the top, work on starting the downswing from the ground up — hips and weight shift — instead of the shoulders.

A phone camera won't measure face angle to the degree the way a radar unit does. But it reads your setup alignment clearly, and whether your shoulders are starting the downswing from outside the line. Birdia analyzes your swing video on-device and flags those patterns, so you know whether your push or pull is coming from setup or from the move itself. If you need the exact face and path numbers, a TrackMan-style radar is the tool to quantify it. With Birdia you can then track whether your setup fix is holding up session after session.

Sources

Frequently asked questions

Is a Push the Same as a Slice?

No. A push starts right and flies straight, because face and path match. A slice has the face open relative to the path, so the ball curves right in the air. According to TrackMan, start direction depends mostly on the face, while curve comes from the gap between face and path.

Should I Aim Further Right to Fix a Pull?

No — not unless it's an emergency band-aid on the course. If the pull comes from an over-the-top move, aiming right usually makes the out-to-in path even worse. Fix your actual alignment and the start of the downswing first.

Why Do I Push the Driver but Not My Irons?

It usually comes down to ball position and path. With the driver, the ball sits further forward and the swing is more of a sweep; if the path comes too far from the inside or the body stalls, the face ends up pointing right. The driver's face also carries more weight in start direction than irons do, so any face misalignment shows up more.

Analyze your swing free with Birdia →